Scientists Finally Know What’s Inside A Black Hole

Scientists finally discover what’s inside a black hole
Physicist Enrico Rinaldi used quantum computing and computer learning to describe what is believed to be the interior of a black hole.

What lies at the center of a black hole? A team of scientists led by Enrico Rinaldi, an American physicist at the University of Michigan, has utilized quantum computing and computer learning to decipher the mathematical description of the quantum state of the matrix model, shedding light on what may lie inside a black hole.

The study was based on the holographic principle, which postulates that the two fundamental theories of particles and gravity are equivalent to one another. However, the challenge lies in the fact that these ideas are constructed in different dimensions.

Black hole theories
Two theories offer explanations for different dimensions, with only one distinction between them. Gravity exists in three dimensions within a black hole’s geometry, whereas particle physics resides on its surface in two dimensions, similar to a flat disk.

A black hole’s massive mass distorts space-time, creating its gravity that operates in three dimensions. This gravity links mathematically to the particles gyrating above the black hole in two dimensions. Therefore, while a black hole occupies three-dimensional space, it appears to observers as a projection of particles.

According to some scientists, our entire universe could be a holographic depiction of particles, which might provide a consistent quantum explanation of gravity. Enrico Rinaldi explains that in Einstein’s General Relativity theory, there are no particles, only space-time, while in the Standard Model of particle physics, there are no gravitational forces, only particles. Bridging these two theories has been a persistent challenge in physics for decades.

A recent study by Rinaldi and his colleagues, published in the journal PRX Quantum, explores the use of quantum computing and deep learning to investigate holographic duality. Their research focuses on determining the lowest energy state of quantum matrix models, which are mathematical problems that can help probe the nature of this duality.

 

The use of quantum matrix models represents the particle theory. According to holographic duality, the mathematical events that occur in a system representing particle theory can also impact a system representing gravity. Thus, by solving a quantum matrix model, one could gain insights into gravity-related phenomena.

Rinaldi and his colleagues have utilized two matrix models, which are relatively uncomplicated to solve through conventional means but possess all of the attributes of more complex matrix models employed to describe black holes using holographic duality.

“We hope that by understanding the properties of this particle theory through the numerical experiments, we understand something about gravity,” adds Rinaldi. “Unfortunately it’s still not easy to solve the particle theories. And that’s where the computers can help us.”

The ground-state energy E0 as a function of the cutoff for various couplings λ = g2N = 0.2, 0.5, 1.0, and 2.0 for the SU(2) bosonic model. Even (E) and odd (O) values of are plotted with different colors. The other parameters are m2 = 1andc = 0.
The ground-state energy E0 as a function of the cutoff for various couplings λ = g2 N = 0.2, 0.5, 1.0, and 2.0 for the SU(2) bosonic model. Even (E) and odd (O) values of are plotted with different colors. The other parameters are m2 = 1andc = 0. (CREDIT: PRX Quantum)
In string theory, objects are represented by numerical matrix models, where one-dimensional strings correspond to particles in particle theory. The focus of researchers is to determine the specific arrangement of particles in the ground state, the lowest energy state of the system, by solving these matrix models. Unless something is added to the system that causes it to be perturbed, it remains unchanged in its natural state.

“It’s really important to understand what this ground state looks like, because then you can create things from it,” Rinaldi says. “So for a material, knowing the ground state is like knowing, for example, if it’s a conductor, or if it’s a super conductor, or if it’s really strong, or if it’s weak. But finding this ground state among all the possible states is quite a difficult task. That’s why we are using these numerical methods.”

According to Rinaldi, the numbers in matrix models can be thought of as grains of sand. When the sand is level, it corresponds to the ground state of the model. But if there are ripples in the sand, you need to find a way to smooth them out. To tackle this problem, the researchers resorted to quantum circuits.

These circuits are depicted as wires, and each wire is associated with a qubit, a quantum information bit. Gates, which are quantum operations that dictate how information flows through the wires, are placed on top of the wires.

The violation of the singlet constraint αE0| ˆ G2 α|E0 as a function of the cutoff for various couplings λ = g2N = 0.2, 0.5, 1.0, and 2.0 for the SU(2) bosonic model. Even (E) and odd (O) values of are plotted with different colors in logarithmic scale. The other parameters are m2 = 1andc = 0.
The violation of the singlet constraint αE0| ˆ G2 α|E0 as a function of the cutoff for various couplings λ = g2 N = 0.2, 0.5, 1.0, and 2.0 for the SU(2) bosonic model. Even (E) and odd (O) values of are plotted with different colors in logarithmic scale. The other parameters are m2 = 1andc = 0. (CREDIT: PRX Quantum)
“You can read them as music, going from left to right,” the author adds. “If you read it as music, you’re basically transforming the qubits from the beginning into something new each step. But you don’t know which operations you should do as you go along, which notes to play. The shaking process will tweak all these gates to make them take the correct form such that at the end of the entire process, you reach the ground state. So you have all this music, and if you play it right, at the end, you have the ground state.”

Rinaldi and colleagues established the mathematical representation of the quantum state of their matrix model, which they referred to as the quantum wave function. Subsequently, they employed a unique neural network to determine the ground state of the matrix, which is the state with the lowest energy level.

To achieve this, the neural network’s parameters underwent an iterative optimization process, aimed at leveling all the grains in the bucket of sand, until the matrix’s ground state was found.

The researchers were successful in determining the ground state of the two matrix models using both methods. However, the quantum circuits were constrained by the limited number of qubits available in current quantum hardware. With only a few dozen qubits at their disposal, increasing the complexity of the circuit would become prohibitively expensive, much like adding too many notes to a sheet of music would make it more difficult to play accurately.

We take the five eigenstates of ˆ H (|Ej ) with the smallest values of αEj| ˆ G2 α|Ej and the fivelowesteigenstates for ˆ H (|Ej with j = 0,…,4) and we plot them as afunction of their energy ˆ H for c = =4, m2 =1, λ =g2N =0.2in the SU(2) bosonic model. We can see the deformation does not affect the low-lying modes; it just removes the nonsinglet modes.
We take the five eigenstates of ˆ H (|Ej ) with the smallest values of αEj| ˆ G2 α|Ej and the five lowest eigen states for ˆ H (|Ej with j = 0,…,4) and we plot them as a function of their energy ˆ H for c = =4, m2 =1, λ =g2 N =0.2 in the SU(2) bosonic model. We can see the deformation does not affect the low-lying modes; it just removes the non singlet modes. (CREDIT: PRX Quantum)
“Other methods people typically use can find the energy of the ground state but not the entire structure of the wave function,” Rinaldi said. “We have shown how to get the full information about the ground state using these new emerging technologies, quantum computers and deep learning.”

“Because these matrices are one possible representation for a special type of black hole, if we know how the matrices are arranged and what their properties are, we can know, for example, what a black hole looks like on the inside. What is on the event horizon for a black hole? Where does it come from? Answering these questions would be a step towards realizing a quantum theory of gravity.”

According to Rinaldi, the findings serve as a crucial milestone for forthcoming research on quantum and machine learning algorithms. These algorithms can be applied by scholars to investigate quantum gravity through the concept of holographic duality.

In the next phase, Rinaldi, together with Nori and Hanada, is examining how these algorithms’ outcomes can expand to more extensive matrices and how immune they are to the influence of “noisy” effects, which can lead to inaccuracies.

Major components of black holes
A black hole consists of several key components, each contributing to its complex nature:

Singularity:
At the very center of a black hole lies the singularity, a point where gravity is so intense that spacetime is infinitely curved, and the laws of physics as we know them break down. It is thought to be an infinitely small, dense point.

Event Horizon:
The event horizon is the “point of no return.” Once anything, including light, crosses this boundary, it can no longer escape the black hole’s gravitational pull. The event horizon defines the black hole’s size and is often the most recognizable feature.

Photon Sphere:
Just outside the event horizon, the photon sphere is a region where light can orbit the black hole due to its extreme gravity. Photons (light particles) can temporarily circle the black hole before either escaping or being pulled in.

Accretion Disk:
Many black holes are surrounded by an accretion disk, a rotating ring of gas, dust, and other matter spiraling toward the event horizon. The intense friction in the disk heats the material, causing it to glow and emit radiation, often making black holes detectable.

Doppler Beaming (Relativistic Beaming):
Doppler beaming occurs when material, such as jets or particles in the accretion disk, moves at relativistic speeds (close to the speed of light). As the material moves toward the observer, the radiation it emits is compressed, leading to a boost in brightness and intensity—this is the “beaming” effect. Conversely, material moving away from the observer appears dimmer.

Ergosphere (for rotating black holes):
In rotating (Kerr) black holes, there is an additional region called the ergosphere. It lies just outside the event horizon and is where spacetime is dragged along with the black hole’s rotation. Objects within the ergosphere can still escape the black hole’s gravity if they gain enough energy.

Jets:
Some black holes, particularly those in active galaxies, can eject powerful jets of charged particles along their rotational axis. These jets can travel vast distances into space and are caused by the magnetic fields generated by the accretion disk.

Each of these parts plays a role in shaping the behavior of black holes and their interactions with surrounding matter and spacetime.

Subscribe. Share. Stay Tuned. The revolution will not be televised 2RAW4TV.TV

Reviews

100 %

User Score

1 ratings
Rate This

Sharing

Leave your comment